Home / Tools / Guitar Separator
Guitar Separator
Lift the guitar out of a full mix, trim the drum bleed, and then go one level deeper (split lead from rhythm, or acoustic from electric) so you can learn a part, loop a riff, or build a backing without it.
Pull the guitar out, then go one level deeper.
Separate the guitar from the full mix, then split that stem again into Lead & Rhythm or Acoustic & Electric.
Upload a song & isolate guitarStep by step
- Upload the song
MP3, WAV, M4A or OGG. A clean source separates better than a compressed rip.
- Isolate the guitar stem
Solo the guitar channel and use the mixer to trim any drum bleed.
- Split it, then export
Lead vs rhythm or acoustic vs electric, then download lossless WAV.
How guitar isolation works, and why it is a two-stage job
The first stage is ordinary stem separation: our AI model splits the whole song and assigns everything it recognises as guitar to a dedicated stem. Guitar is one of the harder families to separate cleanly because its frequency range overlaps heavily with vocals, piano and cymbals, and because a distorted electric guitar spreads energy across a wide band. So the isolated stem usually carries a little bleed, most often high-frequency wash from the drum kit.
That is why the mixer matters. Once the guitar is on its own channel you can lower the drum stem, roll off some top end with the EQ, and tighten the isolation without any destructive processing. For many uses, such as learning a part by ear or looping a riff, the raw guitar stem is already enough.
The second stage is the interesting one. A single guitar stem often contains two distinct parts: a lead line and a rhythm bed, or an acoustic strum under an electric solo. Because those parts differ in timbre and stereo placement, a further split can separate them, giving you the lead on one channel and the rhythm on another. It is not flawless (tightly doubled parts resist it), but on well-arranged mixes it works surprisingly well.
What guitarists use it for
- Learning parts by ear: hear the guitar with nothing on top of it, loop the hard bar, slow nothing else down.
- Lead vs rhythm study: separate the solo from the strumming to work on each independently.
- Play-along backing: mute the guitar and perform the part yourself over the rest of the band.
- Transcription source: feed the isolated line into audio-to-MIDI for a clean, editable transcription.
Related tools
Frequently asked questions
Can I split the guitar into lead and rhythm?
Yes. After the guitar stem is isolated you can run a second split into Lead versus Rhythm, or into Acoustic versus Electric, depending on which distinction is useful for the track.
Why is there drum bleed in the guitar stem?
Cymbals and guitar share a lot of high-frequency energy, so some hi-hat or ride can leak into the guitar stem. Reducing the drum stem's level in the mixer, or using the EQ to tame the top end, cleans most of it up.
Does it work if two guitars are panned hard left and right?
Panning helps. When two guitar parts sit in different places in the stereo field the model has more spatial evidence to tell them apart, so lead-versus-rhythm splitting is usually cleaner on well-panned mixes.
Can I get tab or notation from the isolated guitar?
Once the guitar is on its own you can transcribe it to MIDI or notation. A single isolated guitar line transcribes far more reliably than one buried in a full band mix.
Ready to isolate the guitar?
Upload any track and pull the guitar out in minutes, then split it further.
Open JamScore AI